ABB ACSM1 Manual page 92

92
1.10 ENCODER 2 SPEED
Encoder 2 speed in rpm.
1.11 ENCODER 2 POS
Actual position of encoder 2 within one revolution.
1.12 POS ACT
Actual position of the encoder. The unit depends on parameter
1.13 POS 2ND ENC
Scaled actual position of encoder 2 in revolutions.
1.14 SPEED ESTIMATED
Estimated motor speed in rpm.
1.15 TEMP INVERTER
Measured temperature of the heatsink in Celsius.
1.16 TEMP BC
Braking chopper IGBT temperature in Celsius.
1.17 MOTOR TEMP
Measured motor temperature in Celsius when a KTY sensor is used. (With a PTC sensor, the value is
always 0.)
1.18 MOTOR TEMP EST
Estimated motor temperature in Celsius.
1.19 USED SUPPLY VOLT
Either the user-given supply voltage (parameter
enabled by parameter
1.20 BRAKE RES LOAD
Estimated temperature of the braking resistor. The value is given in percent of the temperature the
resistor reaches when loaded with the power defined by parameter
1.21 CPU USAGE
Microprocessor load in percent.
1.22 INVERTER POWER
Drive output power in kilowatts.
1.26 ON TIME COUNTER
This counter runs when the drive is powered. The counter can be reset using the DriveStudio tool.
Parameters and firmware blocks
FW block: ENCODER
FW block: ENCODER
FW block: POS FEEDBACK
FW block: POS FEEDBACK
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: MOT THERM PROT
FW block: MOT THERM PROT
FW block: VOLTAGE CTRL
47.03 SUPPLVOLTAUTO-ID, the automatically determined supply voltage.
FW block: ACTUAL VALUES
FW block: None
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
(page 256)
(page 256)
(page 219)
60.05 POS UNIT selection.
(page 219)
(see above)
(see above)
(see above)
(page 192)
(page 192)
(page 201)
47.04 SUPPLY VOLTAGE), or, if auto-identification is
(see above)
48.04 BR POWER MAX
(see above)
(see above)
CNT.