ABB ACSM1 Manual page 327

Code Fault
(fieldbus code)
0309 APPL LOADING
(0x6300)
Fault code extension: 8
Fault code extension: 10
Fault code extension: 35
Fault code extension: 38
Fault code extension: 39
Fault code extension:
Other
0310 USERSET LOAD
(0xFF69)
0311 USERSET SAVE
(0xFF69)
0312 UFF OVERSIZE
(0x6300)
0313 UFF EOF
(0x6300)
0314 TECH LIB INTERFACE
(0x6100)
0315 RESTORE FILE
(0x630D)
Cause
Application file incompatible or
corrupted.
Note: This fault cannot be
reset.
Template used in the application
incompatible with drive
firmware.
Parameters defined in the
application conflict with existing
drive parameters.
Application memory full.
Too many powerfail parameters
Memory unit full
Corrupted application file
Loading of user set is not
successfully completed
because:
- requested user set does not
exist
- user set is not compatible with
drive program
- drive has been switched off
during loading.
User set is not saved because
of memory corruption.
UFF file is too big.
UFF file structure failure
Incompatible firmware interface
Note: This fault cannot be
reset.
Restoration of backed-up
parameters failed.
What to do
Check the fault logger for a fault code
extension. See appropriate actions for each
extension below.
Change the template of the application in
DriveSPC.
Check the application for conflicting
parameters.
Reduce the application size and reload the
application.
Reduce the powerfail parameters from the
application.
Reduce the application size and reload the
application.
Reload application.
If fault is still active, contact your local ABB
representative.
Reload.
Check the setting of parameter
UNIT SUPPLY.
If the fault still occurs, contact your local ABB
representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
The fault is reset after a successful
restoration via the control panel or
DriveStudio.
327
95.01 CTRL
Fault tracing