ABB ACSM1 Manual page 122

122
10.02 EXT1 START IN1
Selects the source 1 for the start and stop commands in external control location EXT1. See
parameter
Note: This parameter cannot be changed while the drive is running.
Bit pointer: Group, index and bit
10.03 EXT1 START IN2
Selects the source 2 for the start and stop commands in external control location EXT1. See
parameter
Note: This parameter cannot be changed while the drive is running.
Bit pointer: Group, index and bit
10.04 EXT2 START FUNC
Selects the source for the start and stop control in external control location EXT2.
Note: This parameter cannot be changed while the drive is running.
(0) Not sel
(1) In1
(2) 3-wire
(3) FBA
(4) D2D
(5) IN1 F IN2R
Parameters and firmware blocks
FW block:
10.01 EXT1 START FUNC
FW block:
10.01 EXT1 START FUNC
FW block:
No source selected.
Source of the start and stop commands are selected by parameter
10.05 EXT2 START
Par.
0 -> 1
1 -> 0
Source of the start and stop commands are selected by parameters
10.05 EXT2 START IN1
controlled as follows:
Par.
Start and stop control from the source selected by parameter
CW
Start and stop control from another drive via D2D Control Word.
The source selected by
signal, the source selected by
start signal.
Par.
DRIVE LOGIC (see above)
selections (1) In1 and (2)
DRIVE LOGIC (see above)
selection (2) 3-wire.
DRIVE LOGIC (see above)
IN1. The start/stop is controlled as follows:
10.05 Command
Start
Stop
and 10.06 EXT2 START
10.05 Par. 10.06 Command
0 -> 1 1
Any 1 -> 0
Any 0
USED.
10.05 EXT2 START IN1
10.05 Par. 10.06
0 0
1 0
0 1
1 1
3-wire.
IN2. The start/stop is
Start
Stop
Stop
is the forward start
10.06 EXT2 START IN2 is the reverse
Command
Stop
Start forward
Start reverse
Stop
10.13 FB