Group 97 User Motor Par - ABB ACSM1 Manual

Group 97 USER MOTOR PAR
User adjustment of motor model values estimated during motor ID run. The values
can be entered in either "per unit" or SI.
97
97.01 USE GIVEN PARAMS
Activates the motor model parameters
Notes:
• Parameter value is automatically set to zero when motor ID run is selected by parameter
IDRUN
characteristics identified during the motor ID run.
• This parameter cannot be changed while the drive is running.
(0) NoUserPars
(1) UserMotPars
(2) UserPosOffs
(3) AllUserPars
97.02 RS USER
Defines the stator resistance R
0...0.5 p.u. (per unit)
97.03 RR USER
Defines the rotor resistance R
Note: This parameter is valid only for asynchronous motors.
0...0.5 p.u. (per unit)
97.04 LM USER
Defines the main inductance L
Note: This parameter is valid only for asynchronous motors.
0...10 p.u. (per unit)
97.05 SIGMAL USER
Defines the leakage inductance
Note: This parameter is valid only for asynchronous motors.
0...1 p.u. (per unit)
97.06 LD USER
Defines the direct axis (synchronous) inductance.
Note: This parameter is valid only for permanent magnet motors.
0...10 p.u. (per unit)
FW block: None
MODE. The values of parameters
Parameters
The values of parameters
The value of parameter
Parameters
The values of parameters
and the value of parameter
FW block: None
of the motor model.
S
Stator resistance.
FW block: None
of the motor model.
R
Rotor resistance.
FW block: None
of the motor model.
M
Main inductance.
FW block: None
σ
L
Leakage inductance.
FW block: None
Direct axis (synchronous) inductance.
97.02...97.14 and the rotor angle offset parameter 97.20.
97.02...97.20 are updated according to the motor
97.02...97.20 inactive.
97.02...97.14
97.20
97.02...97.14 are inactive.
97.02...97.14
97.20
.
S
are used in the motor model.
is used as the rotor angle offset.
are used in the motor model,
is used as the rotor angle offset.
Parameters and firmware blocks
271
99.13