ABB ACSM1 Manual page 180

180
33.09 SUPERV3 FUNC
Selects the mode of supervision 3.
(0) Disabled
(1) Low
(2) High
(3) Abs Low
(4) Abs High
33.10 SUPERV3 ACT
Selects the signal to be monitored by supervision 3. See parameter
Value pointer: Group and index
33.11 SUPERV3 LIM HI
Sets the upper limit for supervision 3. See parameter
-32768...32768
33.12 SUPERV3 LIM LO
Sets the lower limit for supervision 3. See parameter
-32768...32768
33.17 BIT0 INVERT SRC
Parameters
shown by parameter
This parameter selects the source bit whose inverted value is shown by parameter
INVERTED
DI1
DI2
DI3
Parameters and firmware blocks
FW block:
Supervision 3 not in use.
When the signal selected by parameter
below the value of parameter
SUPERV STATUS
exceed the value of parameter
When the signal selected by parameter
exceeds the value of parameter
SUPERV STATUS
below the value of parameter
When the absolute value of the signal selected by parameter
SUPERV3 ACT
LIM LO, bit 2 of
the absolute value of the signal must exceed the value of parameter
33.11 SUPERV3 LIM
When the absolute value of the signal selected by parameter
SUPERV3 ACT
HI, bit 2 of
absolute value of the signal must fall below the value of parameter
33.12 SUPERV3 LIM
FW block:
FW block:
Upper limit for supervision 3.
FW block:
Lower limit for supervision 3.
FW block: None
33.17...33.22 enable the inversion of freely selectable source bits. The inverted bits are
6.17 BIT INVERTED
SW, bit 0.
Digital input DI1 (as indicated by
Digital input DI2 (as indicated by
Digital input DI3 (as indicated by
SUPERVISION (see above)
33.12 SUPERV3 LIM
is activated. To clear the bit, the signal must
33.11 SUPERV3 LIM
33.11 SUPERV3 LIM
is activated. To clear the bit, the signal must fall
33.12 SUPERV3 LIM
falls below the value of parameter
6.14 SUPERV STATUS
HI.
exceeds the value of parameter
6.14 SUPERV STATUS is activated. To clear the bit, the
LO.
SUPERVISION (see above)
SUPERVISION (see above)
33.09 SUPERV3
SUPERVISION (see above)
33.09 SUPERV3
SW.
2.01 DI
2.01 DI
2.01 DI
33.10 SUPERV3 ACT
LO, bit 2 of
HI.
33.10 SUPERV3 ACT
HI, bit 2 of
LO.
33.10
33.12 SUPERV3
is activated. To clear the bit,
33.10
33.11 SUPERV3 LIM
33.09 SUPERV3 FUNC.
FUNC.
FUNC.
6.17 BIT
STATUS, bit 0).
STATUS, bit 1).
STATUS, bit 2).
falls
6.14
6.14