Drive Logic; Group 10 Start/Stop - ABB ACSM1 Manual

120
Group 10 START/STOP
Settings for
• selecting start/stop/direction signal sources for external control locations EXT1
and EXT2
• selecting sources for external fault reset, run enable and start enable signals
• selecting sources for emergency stop (OFF1 and OFF3)
• selecting source for jogging function activation signal
• enabling the start inhibit function.
See also section
10
Firmware block:

DRIVE LOGIC

(10)
This block
• selects the sources for the start/
stop/direction signals for external
control locations EXT1 and EXT2
• selects the sources for external
fault reset, run enable and start
enable signals
• selects the sources for emergency
stop (OFF1 and OFF3)
• selects the source for jogging
activation signal
• enables the start inhibit function.
Parameters and firmware blocks
Jogging on page 50.
DRIVE LOGIC