GE Centricity RA600 Service Manual page 99

Software Configuration
d. Right click on the monitor 1 rectangle and deselect Attached.
e. Click on the Apply button. The display switches to the primary monitor.
f. Click OK to close the Display Properties window.
13. For C monitors and 18" flat panel monitors perform the following steps (for demo units only,
simply click OK & go to section 3-2):
a. Right click on the desktop and select Properties.
b. In the Display Properties window, select the Settings tab.
c. Click Advanced.
d. In the Monitor Display Properties window set the Refresh Frequency rate to 85 Hz for a C
monitor or to 75 Hz for an 18" flat panel, then click OK to close the Display Properties
window.
3-2 Install Centricity RA600 License File
1. Locate the Centricity RA600 Configuration floppy (license file diskette).
2. Copy the RA600 license file into the d:\AMI_60\bin\ folder (where d: is the installation drive).
3. Remove the blank license.dat file from the d:\AMI_60\bin folder, if present.
4. Rename the RA600 license file (e.g. 2x20020712007_.dat) to license .dat.
5. In the d:\AMI_60\bin folder, execute the RunLCfg.exe program. In the resulting License
Configuration popup window, check that the radio button seleted in the Product Type group
matches the item following Feature on the license file sheet provided with the license diskette.
(e.g. Standard, Diagnostic, etc.)
6. Click Test and note that the resulting message says that the test succeeded.
CNF 001 Initial Power Up and Software Configuration
Page 99