Sw 005 Removing Applications Software - GE Centricity RA600 Service Manual

Software Procedures
n

SW 005 Removing Applications Software

Section 1: Introduction
This job card describes how to remove the Workstation applications.
Section 2: Prerequisites
u
OS is loaded.
u
Video board(s) switch settings are set correctly.
u
Video board(s) are properly Installed in the workstation.
u
Video cable(s) properly connected.
u
Video board driver installed.
Section 3: Procedure
1. Login as user: Administrator. There may be no password set at this time. If a password has
been set it could be: (CANal1).
2. Select Start > Settings > Control Panel > Add Remove Programs.
3. Click on the RadWorks Workstation (RA600) software package.
4. Click on Remove.
Page 197
SW 005 Removing Applications Software