GE Centricity RA600 Service Manual page 54

Hardware Installation
Note:
The components used in the workstation are static sensitive. Observe static precautions when
performing this procedure.
1. Power off the system.
2. Remove the left-hand half of the workstation case.
l
Slide the rear padlock hasp toward the chassis center and press the release button on the
lower front of the bezel and remove the left side of the case.
l
For detailed removal instructions, refer to the Dell Online Documentation, Dell PowerEdge
System Documentation, Dell PowerEdge 1400, PowerEdge 1400 Installation and
Troubleshooting Guide, Checking Inside the Compuuter.
3. Locate an available PCI slot for the Adaptec AHA-2930U SCSI card.
Note:
Be sure to observe proper ESD safety precautions when inserting the SCSI card.
4. Install the Adaptec AHA-2930U SCSI card into the PCI slot.
5. Replace the workstation case cover.
6. Connect one end of the 50-Pin SCSI Interface cable to the SCSI card connector at the rear of
the computer and the other end to the SCSI peripheral device. Refer to the device User's
Manual for detailed instructions.
7. Power-on the system.
8. The Windows 2000 operating system provides plug & play recognition and driver selection for
the Adaptec AHA-2930U SCSI Card.
Note:
If the system does not recognize the card or otherwise indicates driver problems, install the
driver supplied with the card per the installation instructions provided.
Page 54
IST 007 Adaptec SCSI Card Installation