GE Centricity RA600 Service Manual page 256

Troubleshooting
Note:
Be sure to observe proper ESD safety precautions when inserting the frame grabber board.
3. Depending on which channel you will use to connect the video IN, set one of the following
jumpers.
Video IN
CA1
CA2
CA3
CA4
4. Replace the 1400 side cover and restart the Centricity RA600 system.
5. Connect the video source to the CA channel you have selected and then connect the
corresponding CT channel to the monitor.
6. Follow job card
autosync function of the softwae will automatically detect the channel that has a valid video
signal.
Note:
For more details on jumper settings refer to the Hi Def Accura card User Manual, Chapter 2.
This manual may be down loaded from http://www.foresightimaging.com or from the ROC
website, Http://e.87.17.176, under Radworks > drivers > Frame Grabbers.
TSG 015 Connect Frame Grabber to Monitor that has no pass-through
Jumper Jumper
No. Setting
J3 B
J5 B
J8 B
J10 B
SW 007 to install the Imagraph software and configure the channel. The
Page 256
Video OUT
CT1
CT2
CT3
CT4