Sw 010 Installing Film Digitizer Scsi Software - GE Centricity RA600 Service Manual

Software Procedures
n

SW 010 Installing Film Digitizer SCSI Software

Section 1: Introduction
This job card outlines installation and set-up of the software for a film digitizer as a SCSI device.
Section 2: Items Required
Centricity RA600 (RadWorks 6.0) CD
Section 3: Prerequisites
u
Ensure that the RA600 workstation has been installed with both hardware and software
configured to GE specification. The RadWorks Acquisition module must be installed as part of
the RA600 (RadWorks 6.0) application.
u
Ensure that proper SCSI ID has been set on the device interface card, if necessary. Refer to
manufacturer's documentation for details.
Section 4: Procedure
1. Power up the RA600 workstation and, from the Windows 2000 desktop, log in as the
Administrator (need administrator privliges to load software).
2. Click Start > Settings> Control Panel > Add/Remove Software.
3. Select the RadWorks 6.0 program and click the Change button.
4. Click Next in the Welcome window of the RadWorks Setup wizard.
SW 010 Installing Film Digitizer SCSI Software
Page 224