Sw 014 Installing Centricity Ra600 Software Patch - GE Centricity RA600 Service Manual

Software Procedures
n

SW 014 Installing Centricity RA600 Software Patch

Section 1: Introduction
This job card describes how to install a software patch to the RA600 application software.
Section 2: Prerequisites
u
OS is loaded.
u
Video monitor(s), board(s) and driver(s) are properly Installed & configured in the workstation.
u
Centricity RA600 software application is installed and configured to the site.
u
Software patch CD-ROM is at hand.
Section 3: Procedure
1. Login as user: Administrator. There may be no password set at this time. If a password has
been set it could be: CANal1.
2. Insert the patch CD-ROM into the CD-ROM drive.
3. Navigate to the release notes on the CD-ROM and double click on the file to open it. Read the
entire file and follow the instructions to intall the patch.
4. Remove the patch CD-ROM from the CD-ROM drive.
SW 014 Installing Centricity RA600 Software Patch
Page 233