GE Centricity RA600 Service Manual page 140

Software Configuration
In the system shown in the preceding screen capture, there is one BarcoMed 3MP2FH Imaging
Board installed with Dual View with Dual View enabled. Rectangles "1" and "2" represent the two
CORONIS displays of a single board/dual head installation. Your configuration may look different.
DualView can be installed with CORONIS on a BarcoMed 3MP2FH by following the steps listed
below.
1. Follow the instructions in the section "Initial BarcoMed Display Driver Installation" to install the
BarcoMed 3MP2FH driver for each 3MP2FH graphics board installed in the system.
2. Double-click the "Add/Remove Hardware" icon in the Microsoft Control Panel. The "Add/
Remove Hardware Wizard" appears.
3. Click "Next ".
4. In the "Choose a Hardware Task" page of the wizard select the radio button beside "Add/
Troubleshoot a device", and click "Next ". Windows will now search for a new Plug and Play
hardware device to install. When Windows fails to find a new Plug and Play hardware device,
the "Choose a Hardware Device" page of the wizard will appear.
5. Select "Add a new device", and click "Next ".
6. In the "Find New Hardware" page of the wizard select the radio button beside "No, I want to
select the hardware from a list" and click "Next ".
7. In the "Hardware Type" page of the wizard, highlight "Display Adapters" and then click "Nex t".
8. In the "Select a Device Driver" page of the wizard select "BARCO Metheus" in the
Manufacturers column and "BarcoMed 3MP2FH" in the Models column. Click "Next ".
9. The "Start Hardware Installation" dialog box appears. Click "Next".
10. Windows will warn you that a digital signature was not found. Click "Yes" to continue the
installation.
CNF 007 Configuring Barco 3MP2FH Video Driver
Page 140