Sw 006 Single Media Archive (Sma) Install, Configure & Test - GE Centricity RA600 Service Manual

Software Procedures
n
SW 006 Single Media Archive (SMA) Install, Configure & Test
Section 1: Introduction
This job card describes how to install, configure, and use the Single Media Archive CD-RW
drive.The integrated
VOB software enables the SMA function
Section 2: Items Required
u
Centricity RA600 Application CD-ROM and any included software patch(es).
u
Approved SMA Read-Write drive with power and signal cables.
u
Writable CDs approved for use with the SMA drive.
Section 3: Prerequisites
Installation of SMA is part of the RA600 installation. The prerequisites are therefore the same as job
card SW 002. plus the following:
u
SMA Read-Write drive must be connected to the RA600 computer according to the drive
manufacturer's directions.
Section 4: Procedure
1. Run the RA600 installation, enabling the SMA module in the process.
SW 006 Single Media Archive (SMA) Install, Configure & Test
Page 199