GE Centricity RA600 Service Manual page 141

Software Configuration
11. When the drivers have finished copying, click "Finish" on the "Completing Found New
Hardware Wizard" page to complete the installation.
12. Windows may now prompt you to reboot your system. Click "Yes ". Boot normally and log on
using an account with administrator privileges.
Repeat steps 1 – 12 above for each 3MP2FH board for which you want to have
the DualView feature enabled.
4-4 Setting the Resolution of Your CORONIS Panel with DualView enabled
Once you have completed the installation of the separate screens with DualView,
you need to set the resolution for each display. Both screens of each imaging
board cannot be enabled at the same time unless their display properties match.
1. To set the resolution for your CORONIS display panel(s) under DualView, right click on the
desktop and select "Properties ". Select the "Settings" tab (see figure 5 earlier in this chapter).
Now select the rectangle that represents the BarcoMed 3MP2FH Imaging Board you are
working with.
Note:
If you are using the VGA capabilities of your BarcoMed 3MP2FH Imaging Board, the resolution
for that board will still be set to a VGA resolution of "640 x 480" pixels. If the BarcoMed
3MP2FH Imaging Board is not running VGA, the device may not be enabled yet. To enable the
device check the "Extend my Windows desktop onto this monitor" checkbox. Click the "Apply"
button.
2. Detach one of the displays by right clicking on it and deselecting "Attached ". Click the "Apply"
button.
Note:
Since Windows 2000 will not let you detach the primary display, you may need to temporarily
make another display the primary display.
3. For the display which is still attached click on the "Advanced" Button.
CNF 007 Configuring Barco 3MP2FH Video Driver
Page 141