GE Centricity RA600 Service Manual page 259

Disassembly & Reassembly Procedures
Section 3: Procedure
Video boards should be installed in slots 4 & 6 (use slot 6 for the second board, if applicable)
The following switch settings are used to disable the V
(3MP2FH) video boards and must be set correctly for the system to boot. This does not apply to 'C'
monitor systems.
MD5PCX (A+ Dual Output)
MD4PCV (A Resolution)
MD2PCI (B Resolution)
3MP2FH (1st Board)
3MP2FH (2nd Board) if applicable
Video Board
Page 259
DR 001 Video Board Switch Settings
settings of the Dome (MDxxxx) and Barco
GA
Dip Switch 1 Settings
SW 1 SW 2 SW 3
On Off On
On Off On
Using Jumper J4 place jumper
Over Pins 2-3 (Pin 1 is top pin)
On
On On
Off
Off On
SW 4
On
On
On
On