GE Centricity RA600 Service Manual page 91

Hardware Installation
1. Turn off the power to your computer and disconnect the power cord.
2. Remove the chassis cover according to the manufacturer's instructions. Be sure to observe
safety warnings.
3. Install the first card in 3rd slot from bottom and the 2nd card in the bottom slot. Be sure that the
board is seated firmly in the slot. See
4. Secure the card to the chassis with the PC's I/O panel mounting screw, and replace the
chassis cover.
5. Connect the primary display (left-most display in a linear configuration, top-most in a vertical
configuration) to the uppermost connector on the 3MP2FH (the output farthest from the
motherboard – "VID 1" in figure 3) using the provided DVI cable. Connect the secondary
display to the other connector on the board in the same manner used for the primary display.
Illustration 3-40:Video Outputs for 3MP2FH
6. Reconnect the power cord, turn on the power, and boot the system as usual.
IST 012 Installing Barco 3MP2FH Video Board
Illustration 3-39
Page 91
for correct location.