Honeywell DPR180 Product Manual page 56

4. CONFIGURATION
4.1 INTRODUCTION
The recorder can be configured - using the front keyboard or by using the PC configurator.
When using the keyboard there are two possible levels of password that can be configured. Password 1
provides limited configuration access as shown on the configuration sheet (See page 4-92). Password 2
provides full configuration of all parameters (See page 4-93).
Page 4-2 provides a key to each explanation for the individual parameters.
To begin configuration you only need to press SET UP. The recorder will indicate "CONFIGURATION", "
ACCESS" and wait for a password to be entered if one has been programmed. If no password has been
programmed the recorder will display the "READ/WRITE", "ANALOG INPUT" position (see programming
matrix). You can now use the LEFT or RIGHT side arrows to select the sub-matrix you want to configure
(i.e. ANALOG INPUT, CHART, ALARM etc.) or the UP or DOWN arrows to select the READ/WRITE,
COPY, PRINT CONF or SERVICE matrices and then use the LEFT or RIGHT arrow to enter into one of
these sub-matrices. When you have selected the sub-matrix that you want to configure you only need to
press ENTER to begin configuration of this sub-matrix.
Each sub-matrix such as ANALOG INPUT has a number of parameters associated with it that need to be
configured in order to set up that parameter and channel. Each parameter needs to be configured for each
input. To exit from the configuration mode press DISPLAY or SET UP keys.
4-2