Communication Firmware Upgrade - Honeywell DPR180 Product Manual

Error message
Firmware file does not exist in
Folder contains invalid firmware files
Hardware Error. The Upgrade
Firmware will be aborted
Invalid entry
Invalid path or file name
Invalid recorder address
No relay card present in the device!
No Response received from Device
Printer not available
Protocol Error
Protocol Error. The Upgrade
Firmware will be aborted
Ram Write Error. The Upgrade
Firmware will be aborted
Tag not found
The disk is not formatted.
The second destination line must be
superior at the first.
The selected file is not valid for
Upgrade Firmware. The Upgrade
Firmware will be aborted
5-25
Error Classification
Error during firmware extraction
Error during firmware extraction
Firmware upgrade error
Error message when values of
parameters are not within valid
range
Error during firmware extraction
Invalid recorder address is typed
Communication error
Communication error
Error on non-availability of printer
Communication error
Firmware upgrade error
Firmware upgrade error
Open configuration
Error during an export operation
Error during an Copy Line
operation
Firmware upgrade error
5. PC CONFIGURATION
Corrective action
Ensure that ICOMp.exe and the firmware
files (REC.Z for main firmware and
CBREC.Z for communication board
firmware) are in the location indicated.
Place the correct type and uncorrupted
firmware files in the folder and retry the
operation.
A hardware error has been encountered.
Contact us for assistance.
The value of the parameter is outside its
specified range. Enter a value that is
within the range for the parameter.
Check if a proper path is provided to the
firmware file. To avoid typographical
errors use the browse button to locate
the folder containing the firmware files.
Provide a recorder address which is
within the 0-99 range.
Insert a relay card into the recorder and
retry the operation.
Check connection between PC
Configurator and recorder.
Check that correct recorder type is
selected.
Check if the printer is connected and
configured properly before issuing a print
command.
Reset the power of recorder and retry the
operation.
A wrong protocol was used for firmware
upgrade. Re-install the PC Configurator
and try again.
A wrong protocol was used for firmware
upgrade. Re-install the PC Configurator
and try again.
Provide a tag name from the displayed
list of tag names during an open
operation
Format the floppy disk and retry the
operation.
"To" value must be greater than
"Destination Line n" value.
Chose the correct file for firmware
upgrade. (001XX.REC for main firmware
upgrade and 100XX.REC for

communication firmware upgrade)