Power Up - Honeywell DPR180 Product Manual

3.3 POWER UP
WARNING
Before powering up, check your recorder is correctly installed. See section 2, "INSTALLATION".
!
Failure to comply with these instructions could result in death or serious injury
3.3.1 Power up display sequence
After powering up, check the messages appear on the displays in the following order:
3.3.1.1 Display test
Check that all dots for each character, commas and triangle marks are lit.
Upper display shows:
INITIALIZATION
If the communication board is present,
Upper display shows:
INITIALIZATION
Lower display shows:
COMMUNICATION
3.3.1.2 Measure initialization
Upper display shows:
INITIALIZATION
Lower display shows:
MEASURE
During a few seconds, the recorder reads and analyzes every inputs. After these operations of initialization,
input values appear on the 2 displays in run mode.
3-3
3. OPERATION