Warning - Honeywell DPR180 Product Manual

2.1 WARNING

WARNING
To avoid the risk of electrical shock that could cause personal injury, follow all safety notices in
!
this documentation.
Protective earth terminal. Provided for connection of the protective earth supply system
conductor.
Failure to comply with these instructions could result in death or serious injury
POWER SUPPLY
Ensure the source voltage matches the voltage of the power supply before turning on the power. (In the
rear of the recorder, near to the connector of the power supply)
PROTECTIVE GROUNDING
Make sure to connect the protective grounding to prevent an electric shock before turning on the power.
NECESSITY OF PROTECTIVE GROUNDING
To avoid a potential shock hazard, never cut off the internal or external protective grounding wire or
disconnect the wiring of protective grounding terminal.
DEFECT OF PROTECTIVE GROUNDING AND FUSE
Do not operate the instrument when protective grounding or fuse might be defective.
FUSE
To prevent a fire, make sure to use the fuse with specified standard (current voltage, type). Before
replacing the fuse, turn off the power and disconnect the power source. Do not use a different fuse or
short-circuit the fuse holder.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable liquids or vapours. Operation of any
electrical instrument in such an environment constitutes a safety hazard.
NEVER TOUCH THE INTERIOR OF THE INSTRUMENT
Inside this instrument there are areas of high voltage; therefore, never touch the interior if the power
supply is connected. This instrument has an internal changeable system; however, internal inspection
and adjustments should be performed by qualified personnel only.
EXTERNAL CONNECTION
To ground securely, connect the protective grounding before connecting to measurement or control unit.
If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
Do not replace any component (or part) not explicitly specified as replaceable by your supplier
INSTALL INDOOR ONLY
IMPROPER INSTALLATION
2-2
2. INSTALLATION
.