Operator Interface Explanations; Operator Interface - Honeywell DPR180 Product Manual

3.1 OPERATOR INTERFACE EXPLANATION
This section describes the various actions which an operator can initiate through the keyboard, and explains
how to interpret the displays in the different modes of operation available.
3.2 OPERATOR
DISPLAY AND KEYPAD: The display gives a clear indication of action prompts by means of two lines of 16
characters and the keypad consists of 13 keys.
SET UP: To move to configuration mode or to return from parameter configuration to the sub-
•
matrix.
ENTER: To confirm your selected action.
•
: THESE KEYS ARE USED FOR PRODUCT CONFIGURATION.
•
F1 HOLD
Immediate To hold the
display on a
action key
configurable current
channel.
Use and
keys to
change the
channel.
NOTE: The function keys are used in run mode and they control the contents of the display and other
functions. In case of a power loss the configuration is unchanged.
INTERFACE
FUNCTION KEYS
PRINT
To choose an
Immediate printing
action.
The choices are:
- Inhibit/Printing
- Reset paper
length
- Change speed/ int
2 to speed/ int 1
- Print date & time
- Snap shot trace
- Chart advance
- Change group B
to A
- Change group
A+B to B
- Snap shot logic
- Snap shot math
- Start archive/stop
archive
- Remove PCMCIA
RESET ACK
- Math To
Acknowledge
- Occurrence
- Reset all latching
PCMCIA alarm relays
3-2
3. OPERATION
DISPLAY F2
To choose the Immediate
display type in
action key
run mode or to configurable
escape
from
configuration
to run mode