Honeywell DPR180 Product Manual page 196

5.13 ERROR MESSAGES
Messages are listed alphabetically.
Error message
An error occurred while loading
Binary file
An error occurred while saving Binary
file
Bad device type selected
Checksum Error
Configuration is in use. Cannot
remove configuration
Device locked
Device not available
Device or DLL returned an unknown
error. The Upgrade Firmware will be
aborted
Disk full.
Disk not ready.
End Upgrade Failed. The Upgrade
Firmware will be aborted
File already exists
File is in use
5-24
Error Classification
On opening an very old
configuration file
When an error occurs while
saving the binary file
Communication error
Communication error
Error during remove
configuration operation
Communication error
Media in the drive does not exist
Firmware upgrade error
Error during an export operation
Error during an export operation
Firmware upgrade error
Error during an export operation
Error when you try to overwrite a
configuration file that is already in
use
5. PC CONFIGURATION
Corrective action
The binary configuration file is generated
by an old version (pre-7.2) of PC
Configurator, which might not be
supported by the current version.
Retry the same operation. If it persists
close the application and retry.
Ensure that there is no mismatch
between the device type selected
through "On-Line comm.->Device menu",
the configuration to be downloaded and
the type of recorder (DPR 180/DPR 250)
and retry the operation.
The protocol is not performing the
reliable data transfer. Retry the
operation. If the problem persists contact
us for assistance.
The configuration that the user is trying
to remove is open in the PCConfigurator.
Close the configuration and retry the
operation.
Reset the power of recorder and retry the
operation.
Floppy disk is not in the drive. Insert disk.
Close the application and retry the same
operation.
Insert a floppy disk that has sufficient
space to hold the exported configuration.
If there is no disk in the specified drive
insert a disk and retry the operation. If
the drive door of the specified drive is
open, close the drive door and retry the
operation.
The protocol did not provide a reliable
date transfer. Retry the operation.
This error occurs at run time when the
new file name is identical to a file name
that already exists. Specify a unique file
name.
Close the configuration that is being
overwritten from the PC Configurator and
retry the operation.