Auxiliary Output Printed Circuit Board Kit
(Part Number 51404561-501 or 51404561-503)
Summary
Kit Contents
Form 44-45-33-52A
DR 4500A Circular Chart Recorder
Kit Instruction
Form: 44-45-33-52A
Effective: 1/15
Supercedes: 5/98
Enclosed with this instruction is a new Auxiliary Output printed circuit
board for your DR4500A Recorder (Classic or Truline models).
Use the procedures listed in the tables to install, configure, and calibrate
the Auxiliary Output Printed Circuit board. These procedures assume that
you are familiar with the DR4500A recorder. We suggest that you have a
copy of the recorder's product manual on hand for reference.
ATTENTION
Kit Part Number 51404561-503 contains a printed circuit
board that has both Auxiliary output and RS485 Modbus RTU functions.
Refer to Instruction Sheet 44-45-33-58 for information on the RS485
Modbus RTU function.
WARNING
Never access components inside the case with the power
applied.
CAUTION
When handling electronic assemblies, care should be taken to
avoid damage by electrostatic discharge. Use a wrist strap connected to an
earth ground before withdrawing the printed circuit board from its
container and installing it into the recorder.
This kit contains parts to add Auxiliary Output to your DR4500A recorder.
You kit you have received contains the following parts:
Part Number
51404561-001
or
51404561-003
30756005-001
30755139-002
30366609-004
NOTE: You may wish to change or add Table III in your recorder's model
number to equal 1XX to show that the recorder is equipped with the
Auxiliary Output function, or 4XX to show that the recorder is equipped
with the Auxiliary Output and Modbus RTU Communication function.
Auxiliary Output Kit Instruction
Description
Auxiliary Output PCB
or
Auxiliary Output/Modbus RTU Communications PCB
Card Guide (2)
Terminal Block - 2 Position
Tie Wraps (2)
Continued on next page
Page 1 of 8