Multiple Ips Ports Connected To The Same Ip Network - Cisco MDS 9000 series Configuration Manual

Chapter 4 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 4-17
IP Addr 10.1.1.1
iqn.initiator.abc
To enable the trespass feature for a static iSCSI virtual target, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# iscsi virtual-target name
iqn.1987-02.com.cisco.initiator
switch(config-iscsi-tgt)#
Step 3
switch(config-iscsi-tgt)# pwwn
50:00:00:a1:94:cc secondary-pwwn
50:00:00:a1:97:ac
Step 4
switch(config-iscsi-tgt)# trespass
switch(config-iscsi-tgt)# no trespass
Use the show iscsi virtual-target command to verify.
switch# show iscsi virtual-target iqn.1987-02.com.cisco.initiator
target: 1987-02.com.cisco.initiator

Multiple IPS Ports Connected to the Same IP Network

Figure 4-18
IP network.
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
Virtual Target with an Active Primary Port
IP network
iSCSI iSCSI
IP Addr 10.1.1.2
iqn.virtual-target.abc
Port WWN 10:20:10:00:56:00:70:50
Configured node
all initiator permit is disabled
trespass support is enabled
provides an example of a configuration with multiple Gigabit Ethernet interfaces in the same
pWWN a1:94:cc
fcid 0x550002
Primary
FC FC
Secondary
pWWN a1:97:ac
fcid 0610003
Purpose
Enters configuration mode.
Creates the iSCSI target name
iqn.1987-02.com.cisco.initiator.
Maps a virtual target node to a Fibre Channel
target and configures a secondary pWWN.
Enables the trespass feature.
Disables the trespass feature (default).
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
iSCSI High Availability
4-63