Show Crypto Ike Domain Ipsec - Cisco MDS 9000 series Command Reference Manual

show crypto ike domain ipsec

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show crypto ike domain ipsec
To display IKE protocol information, use the show crypto ike domain ipsec command.
Syntax Description initiator
address ip-address
keepalive
key
policy [policy-number]
sa
Defaults To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Command Modes EXEC mode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples The following example shows how to display IKE keepalive value configuration information.
switch# show crypto ike domain ipsec keepalive
keepalive 3600
Related Commands Command
crypto ike domain ipsec
crypto ike enable
Cisco MDS 9000 Family Command Reference
22-42
show crypto ike domain ipsec [initiator [address ip-address] | keepalive |
key [address ip-address] | policy [policy-number] | sa]
Displays initiator configuration information.
Specifies the initiator peer IP address.
Displays keepalive for the IKE protocol in seconds
Displays pre-shared authentication keys.
Displays IKE configuration policies for IPsec. The range is 1 to 255.
Displays IKE Security Associations for IPsec.
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Chapter 22 Show Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x