Main Switch Test/Replacement; Set/Resume/Cancel Switch Test/Replacement - Honda 2002 Accord Manual

Cruise Control
Main Switch Test/Replacement
1. Carefully pry the switch (A) out of the instrument
panel.
T e r m i n a l s i d e o f m a l e
t e r m i n a l s
2. Disconnect the 5P connector (B) f r o m the switch.
3. Check for continuity between the terminals in each
switch position according t o the table.
\ T e r m i n a l
1 2 3 4 5
P o s i t i o n \
1 2 3 4 5
O F F
o o
o
-©-
- o
O N
o - - o
o
- © -
• o
4. If the continuity is not as specified, replace the
switch.
Set/Resume/Cancel Switch Test/
Replacement
1. Remove the t w o screws (A), then remove the
switch (B).
T e r m i n a l s i d e o f m a l e
t e r m i n a l s
2. Check for continuity between the terminals in
switch position according to the table.
• If there is continuity and it matches the table, but
switch failure is occurred on the cruise control
unit input test, check and repair the w i r e harness
on the switch circuit.
• If there is no continuity in one or both positions,
replace the switch.
T e r m i n a l
Position
S E T ( O N )
R E S U M E ( O N )
C A N C E L ( O N )
O
o
- o
- o
- o
4-48