Srs Dtc Troubleshooting - '00 Coupe With Side Airbags - Honda 2002 Accord Manual

DTC Troubleshooting - '00 Coupe w i t h
DTC 11-1: Open or increased resistance in
driver's side airbag inflator
1. Erase the DTC m e m o r y (see page 23-45).
2. Turn the ignition switch ON (II), and check that the
SRS indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator light stay on?
Y E S - G o to step 3.
NO— Intermittent failure, system is OK at this time.
Go t o Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the left side w i r e harness 2P connector
f r o m the driver's side airbag.
5. Connect the special tool (2 Q connector) t o the left
side wire harness 2P connector.
6. Reconnect the battery negative cable.
Side Airbags
7. Erase the DTC m e m o r y .
8. Read the DTC.
is DTC 11-1 indicated?
Y E S - G o t o step 9.
NO—Open or increased resistance in the driver's
side airbag inflator, replace the driver's side
airbag. (see page 2 3 - 2 8 2 ) . •
9. Disconnect the left side wire harness 4P connector
C556 (A) f r o m the SRS main harness 4P connector
(B).
0 7 T A Z - S Z 5 0 1 1 A
10. Connect the special tool (2 Q connectors) to the
SRS main harness 4P connector.
11. Erase the DTC memory.
12. Read the DTC.
Is DTC 11-1 indicated?
Y E S - G o to step 13.
NO—Open or increased resistance in the left side
wire harness; replace the left side wire harness. •
(cont'd)
23-139