Honda 2002 Accord Manual page 639

< 3 »
7. Verify that the shift cable end (A) is properly
installed on the mounting stud (B).
P r o p e r l y I n s t a l l e d :
A B
N o t P r o p e r l y I n s t a l l e d :
Cable end rides on the bottom
of the mounting stud.
8. If not properly installed, remove the shift cable
from the shift lever bracket base, and reinstall the
shift cable. Do not install the shift cable end on the
mounting stud while the shift cable is on the shift
cable bracket base.
10. Remove the 6.0 mm (0.24 in.) pin that was installed
to hold the shift lever.
11. Connect the shift lock solenoid connector and park
pin switch 4P connector.
12. Move the shift lever to each gear, and verify that
the A/T gear position indicator follows the
transmission range switch.
13. Push the shift lock release, and verify that the shift
lever releases.
9. Install and tighten the nut.
8 x 1 . 2 5 m m
2 2 N m (2.2 k g f m , 1 6 I b f f t )
14-129