Table of Contents
Advertisement
0 0
18. Lubricate the threads of each shaft and new
locknuts, and new conical spring washers with ATF.
19. Install the new conical spring washers (A) in the
direction shown, and install the new locknuts (B).
20. Tighten the locknuts to 167 N - m (17.0 kgf-m,
123 Ibfft).
NOTE:
• Do not use an impact wrench, always use a
torque wrench to tighten the locknut.
• Mainshaft locknut has left-hand threads.
21. Stake each locknut into its shaft using a 3.5 mm
punch.
22. For '00-02 models: Install the pitot flange (A) on the
mainshaft idler gear (B), then install the lubrication
pitot pipe (C) and the pitot pipe (D) on the
transmission housing.
23. Set the park lever in the 03 position, then verify that
the park pawl (A) engages the park gear (B).
F
24. If the park pawl does not engage fully, check the
distance between the park pawl shaft (C) and the
park lever roller pin (D) (see page 14-152).
25. Tighten the lock bolt (E), and bend the lock tab of
the lock washer (F) against the lock bolt head.
(cont'd)
14-197
Advertisement
Table of Contents
Troubleshooting
