Table of Contents
Advertisement
Steering Gearbox Installation
1. Before installing the gearbox, slide the rack all the
way to right.
2. Pass the right side of the steering gearbox (A)
above and through the right side of the rear beam.
Be careful not to bend or damage the two power
steering lines and cylinder lines when installing the
gearbox.
B
A
3. Raise the left side of the steering gearbox above
and through the left side of the rear beam. Then
insert the pinion shaft (B) up through the bulkhead.
4. Install the pinion shaft grommet (A). Align the slot
(B) in the pinion shaft grommet with the lug portion
on the valve housing.
/ A
5. Install the mounting cushion (A) on the steering
gearbox.
C, G: 38 N m (3.9 k g f m , 28 Ibfft)
F:
43 N m (4.4 k g f m , 32 Ibfft)
6. Install the mounting brackets (B) over the mounting
cushion, then install the two gearbox mounting bolts
(C). Position the split portion (D) of the mounting
cushion as shown.
7. Install the stiffener plates (E) with the two gearbox
mounting bolts (F) and six stiffener plate attaching
bolts (G). Install the bolts loosely first, then tighten
them securely.
8. Center the steering rack within its stroke.
(cont'd)
17-47
Advertisement
Table of Contents
Troubleshooting
