Wheel Bearing End Play Inspection; Wheel Runout Inspection - Honda 2002 Accord Manual

Front and Rear Suspension
Wheel Bearing End Play Inspection Wheel Runout Inspection
1. Raise the vehicle, and make sure it is securely
supported.
2. Remove the wheels, then reinstall the wheel nuts.
3. Attach the dial gauge. On the front, place the dial
gauge against the hub flange. On the rear, place the
dial gauge against the center of the hub cap.
Front/Rear:
Standard: 0 - 0 . 0 5 mm ( 0 - 0 . 0 0 2 in.)
Front:
Rear:
4. Measure the bearing end play moving the brake
disc inward or outward.
5. If the bearing end play measurement is more than
the standard, replace the wheel bearing.
1. Raise the vehicle, and make sure it is securely
supported.
2. Check for bent or deformed wheels.
3. Set up the dial gauge as shown, and measure axial
runout by turning the wheel.
Front and Rear Wheel Axial Runout:
Standard:
Steel Wheel: 0 - 1 . 0 mm (0 - 0.04 in.)
Aluminum Wheel: 0 - 0 . 7 mm (0—0.03 in.)
Service Limit: 2.0 mm (0.08 in.)
4. Readjust the dial gauge to the position shown, and
measure radial runout.
Front and Rear Wheel Radial Runout:
Standard:
Steel Wheel: 0 - 1 . 0 mm (0 - 0.04 in.)
Aluminum Wheel: 0—0.7 mm (0—0.03 in.)
Service Limit: 1.5 m m (0.06 in.)
5. If the wheel runout is more than the service limit,
replace the wheel.
18-8