®
Parking Brake Switch Test
1. Remove the rear console, and disconnect the
connector (A) from the switch (B).
2. Check for continuity between the positive terminal
and body ground:
• With the brake lever up, there should be
continuity.
• With the brake lever down, there should be no
continuity.
NOTE (Canada): If the parking brake switch is OK,
but the brake system indicator does not function,
do the input test for the daytime running
lights control unit (see page 22-96).
Brake Fluid Level Switch Test
1. Remove the reservoir cap (A). Check that the float
(B) moves up and down freely; if it doesn't, replace
the reservoir cap assembly.
2. Check for continuity between the terminals with the
float in the down position (C) and the up position
(D):
• With the float up, there should be no continuity.
• With the float down, there should be continuity.
19-9