Cruise Control Combination Switch Test/Replacement; Clutch Pedal Position Switch Test - Honda Accord 2008 Manual

07/11/02 09:06:11 61TA0000_040_0048
Cruise Control Combination Switch
Test/Replacement
SRS components are located in this area. Review the
SRS component locations:
• 4-door (see page 24-19)
• 2-door (see page 24-21)
Precautions and procedures (see page 24-23) before
doing repairs or service.
1. Remove the driver's airbag (see page 24-206).
2. Disconnect the connector from the cable reel.
＊０１
3. Check for continuity between the terminals in each
switch position according to the table.
• If there is continuity, and it matches the table, but
switch failure occurred on the cruise control
input test, check and repair the wire harness on
the switch circuit.
• If there is no continuity in one or both positions,
replace the switch (see page 17-25).
＊０２
Position
ＴＡ０８ＡＥ４Ａ１４５０００１７６２５ＦＨＡＴ００
Wire side of female terminals
Terminal
8 9 10
Cruise control
main (ON)
Cruise control
main (OFF)
Set/decel
(PRESSED)
Resume/accel
(PRESSED)
CANCEL

Clutch Pedal Position Switch Test

M/T model
1. Disconnect the 3P connector from the clutch pedal
position switch.
Terminal side of
male terminals
2. Remove the clutch pedal position switch.
3. Check for continuity between the terminals
according to the table.
• If the continuity is not as specified, replace the
clutch pedal position switch.
• If OK, install the clutch pedal position switch and
adjust the pedal height (see page 12-7).
Position
Clutch Pedal
Position Switch
(PRESSED)
Clutch Pedal
Position Switch
(RELEASED)
11 12
ＴＡ０８ＡＥＡＡ１４５０００１７０４５ＦＥＡＴ０２
Terminal
1 2
＊０１
＊０２
3
4-47 4-47