Automatic Transmission
ATF Cooler Flushing (cont'd)
17. Make sure the transmission is in B position.
Fill the transmission with ATF, and run the engine
for 30 seconds or until approximately 0.95 ft
(1.0 US qt, 0.8 Imp qt.) is discharged.
18. Remove the drain hose, and reconnect the cooler
return hose to the transmission.
19. Refill the transmission with ATF to the proper level
(see page 14-113).
ATF Cooler Hoses Replacement
1. Connect the cooler hoses (A) to the lines (B) and the
ATF cooler (C), and secure them with the clips (D)
as shown.
2. Install the clamp (E) on the cooler hoses.
14-126