Table of Contents
Advertisement
0 ®
Bearing Replacement
Special Tools Required
• D r i v e r 07749-0010000
• D r i v e r 07949-3710001
• Driver attachment 07JAD-PH80101
• Attachment, 72 x 75 m m , 07746-0010600
NOTE: Coat all parts w i t h ATF before assembly.
1. To remove the mainshaft bearing (A), countershaft
bearing (B), and secondary shaft bearing (C) f r o m
the transmission housing, expand each snap ring
w i t h the snap ring pliers, then push the bearing out
using the special tools and a press.
NOTE: Do not remove the snap rings unless it's
necessary to clean the grooves in the housing.
2. Install the bearings in the direction s h o w n .
3. Expand each snap ring w i t h the snap ring pliers,
and insert the bearing part-way into the housing
using the special tools and a press.
4. Release the pliers, then push the bearing d o w n into
the housing until the snap ring snaps in place
around it.
5. After installing the bearings verify the f o l l o w i n g :
• The snap rings (A) are seated in the bearing and
housing grooves.
• The ring end gaps (B) are correct.
B: 0 — 7
m m
( 0 - 0 . 2 8 i n . )
14-155
Advertisement
Table of Contents
Troubleshooting
