Table of Contents
Advertisement
S R S
DTC Troubleshooting - '00 Sedan w i t h
DTC 11-1: Open or increased resistance in
driver's side airbag inflator
1. Erase the DTC memory (see page 23-45).
2. Turn the ignition switch ON (II), and check that the
S R S indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator
light stay
on?
Y E S - G o t o step 3.
NO—Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the S R S floor harness 2P connector (A)
from the driver's side airbag (B).
5. Connect the special tool (2 Q connector) to the S R S
floor harness 2P connector.
Side Airbags
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 11-1
indicated?
Y E S - G o t o step 9.
NO —Open or increased resistance in the driver's
side airbag inflator; replace the driver's side
airbag (see page 23-282).•
9. Disconnect the battery negative cable, and wait for
3 minutes.
10. Disconnect the S R S floor harness 2P connector (A)
from the front passenger's side airbag (B).
23-108
Advertisement
Table of Contents
Troubleshooting
