Table of Contents
Advertisement
Cylinder Head installation
1. Clean the cylinder head and block surfaces.
2. Install the cylinder head gasket (A) and dowel pins
(B) on the cylinder block. Always use a new
cylinder head gasket.
A
3. Set the t i m i n g belt drive pulley to TDC. Align the
d i m p l e (A) on the t o o t h of the t i m i n g belt drive
pulley w i t h the pointer (B) on the oil pump.
4 . Clean the camshaft pulley and set it to TDC.
- 1 The " U P " mark (A) o n the camshaft pulley
should be at the t o p .
- 2 Align the TDC grooves (B) on the pulley w i t h
the top edge of the head.
A
B
5. Install the cylinder head on the block.
6. Measure the diameter of each cylinder head bolt at
point A and point B.
B 70 mm (2.8 in.)
A 45 m m (1.8 in.)
7. If either diameter is less than 11.3 m m (0.44 in.),
replace the cylinder head bolt.
8. A p p l y clean engine oil to the bolt threads and under
the bolt heads of all the cylinder head bolts.
(cont'd)
6-51
Advertisement
Table of Contents
Troubleshooting
