Honda Motorcycle Service Manual page 415

ELECTRIC STARTERISTARTER CLUTCH
Carefully insert the brushes into the brush holder.
CAUTION
The sliding surfaces of the brushes can be damaged if
they are not installed properly.
Apply grease to both ends of the armature shaft.
Push and hold the brushes inside the brush holder, and insert
the armature into the case and through the brush holder
from the rear side.
the case
When inserting the armature into the case, hold the armature
CAUTION
Align the tab and groove
The coil may be damaged if the magnet pulls the ar-
mature against the case.
COVER
~ R M A T U R E
Insert the shims in the correct order on the armature shaft.
(For applicable models only.)
Insert the O-ring. (For applicable models only.)
Align the mark (that you made earlier) and instell the covers.
tightly to keep the magnet from pulling the armature against
CAUTION
ing the oil seal lip with the shaft.
Tighten the cover screws.
I
For starter motors that are mounted within a motor mount
hole, check for a damaged O-ring.
In order to prevent damage, grease the O-ring.
Refer to the Model Specific manual for installation.
CAUTION
Overtightening the cable terminal nuts may cause the
terminals to turn inside the starter motor, resulting in
serious damage t o the inner connectors.
Date of Issue: March.1995
0
HONDA MOTOR CO.,LTD.