Switches Inspection; Contact Base Replacement; When The Contact Base Is Mounted With Screws; Switches 25-1 - Honda Motorcycle Service Manual

LIGHTSIMETERSISWITCHES
SWITCHES
INSPECTION
Disconnect the connector that is nearest to the switch that
you are to inspect and check for continuity between the
switch side terminals of the connector.
There should be continuity between the 0----0 positions on
the continuity chart. (Refer to the Model Specific manual for
the continuity chart.)
Example: Turn signal switch
With the switch at L (left), there should be continuity between
the orange and gray wires, and with the switch at R (right),
there should be continuity between the blue and gray wires.
Blue
Wire color
Orange
Switch position
N
When the contact base is mounted with screws;
Remove the ignition switch.
Gray
R
0
I
0
Remove the band and three screws, then remove the switch
from the switch cylinder.
With the turn signal switch at Nbeutral), there should be no
continuity between the wires
CONTACT BASE REPLACEMENT
Reassemble the switch and cylinder with the cylinder shaft
aligned with the notch in the switch hole.
S C ! E W S
I
(cut and discard1
SHAFT
,
r
Date of Issue : March, 1995
0
HONDA MOTOR CO.,LTD.