Limiter Cap (Or Plug) Installation - Honda Motorcycle Service Manual

Rev the engine up slightly from the idle speed and make sure
that engine speed rises and returns smoothly.
AIR SCREW ADJUSTMENT (2-stroke engine only)
Warm the engine up to operating temperature.
Turn the air screw clockwise until it seats lightly, then back it
out to the specification given.
AIR SCREW OPENING: Refer to the Model Specific manual.
CAUTION
Tightening the air screw against its seat will damage the
seat.
Adjust the idle speed with the throttle stop screw.
Adjust by turning the air screw in or out within a 114 turn if
necessary. If the engine cannot be adjusted by turning the air
screw within a 114 turn, check for other engine problems.
THRO'ITLE STOP SCREW
LIMITER CAP (OR PLUG) INSTALLATION
IDLE SPEED: Refer to the Model Specific manual.
LIMITER CAP
If the pilot screw (or air screwl is removed, a new limiter cap
must be installed after the screw is adjusted.
After adjustment, cement the limiter caps over the screws, us-
ing LOCTITP 601 or equivalent. The lirniter cap should be
placed against its stop as shown preventing further adjust-
ment that would enrich the fuel mixture.
Pilot screw: the lirniter cap position permits clockwise rotation
and prevents counterclockwise rotation.
PILOT OR AIR:
Air screw: the limiter cap position permits counterclockwise
I
LIMITER CAP
/
.
rotation and prevents clockwise rotation.
NOTE
/
.
Do not turn the pilot screw (or air screwl when installing
the limiter cam
LlMlTER PLUG
Drive new pilot screw (or air screw) plug into the pilot screw
lor air screw) bore with a 7 mm valve guide driver (PIN
07942-8230000).
When fully seated the plug surface will be recessed 1 mm
LIMITER PLUG
J
Date of issue: March, 1995
o
HONDA MOTOR
co.,LTD.
8-23