Handle Grip Installation; Handlebar Weight Replacement - Honda Motorcycle Service Manual

FRONT SUSPENSION
HANDLE GRIP INSTALLATION
If a choke lever is attached to handlebar,
it
must be installed
onto the handlebar before you install the grip.
Apply Honda Bond A or Honda Hand Grip Cement (U.S.A. on-
ly) to the inside surfaces of the grips and t o the clean surface
of the left handlebar and throttle. Wait 3-6 minutes and in-
stall the grips. Rotate the grips for even application of the
adhesive.
Apply sufficient but not excessive adhesive t o the throttle. Ex-
cessive adhesive, forced into the interior bore of the drum, will
restrict free drum movement on the handlebar.
Allow the adhesive t o dry for at least an hour before using.
HANDLEBAR WEIGHT REPLACEMENT
End-Type Weights:
Remove the mounting screw and the weight
Inner-Type Weights:
Remove the handlebar grip:
Spring pin type:
Drive out the spring pin using a pin driver
.
Retainer ring type:
Straighten the locking tab.
To remove, pull the weight while twisting it
NOTE
.
The inner weight is centered within the bar.
I
HANDLE GRIP
\
INNER WEIGHT
PIN DRIVER
SPRING PIN
\
RUB
LOCKING TAB
CUSHION
/
"UUJ
UER
Date o f Issue : March, 1995
0
HONDA MOTOR CO.,LTD.
Retainer ring type:
Install a new retainer ring t o the inner weight and install the
end weight, aligning the cutout.
Insert the weight into the handlebar, and turn the weight
t o ensure that the locking tab aligns with the hole.
RETAINER LOCKING
NG TAB
END WEIGHT