Shaft Driven Type Removal; Shaft Driven Type Installation - Honda Motorcycle Service Manual

WHEELSITIRES
For mechanical drum brakes, connect the brake rod (or cable)
t o the brake arm and install the adjusting nut loosely. If appli-
cable, connect the torque rod to the brake panel and tighten
the torque rod nut to the specified torque.
Adjust the drive chain slack.
Tighten the rear axle nut to the specified torque.
Secure the axle nut and torque rod nut with a new cotter pin
if required.
For mechanical drum brakes, adjust the rear brake pedal free
play.
For hydraulic disc brakes, install the rear wheel by working the
brake disc between the brake pads. Be careful not to damage
the pads.
With the rear wheel in place, install the axle with the chain
adjuster.
NOTE
On snail cam types, note the proper direction of the
chain adjuster.
Install the chain adjuster and axle nut on the opposite side of
the wheel.
CHAIN
REAR AXLE
UE ROD
AXLE
CHA,N
CHAIN ADJUSTER
SHAFT DRIVEN TYPE
Fit the drive chain over the driven sprocket.
Removal
For drum brakes, disconnect the brake rod (or cable) and tor-
que rod from the brake panel.
Remove the axle nut and loosen the axle pinch bolt.
Remove the rear axle.
For hydraulic disc brakes, move the caliper assembly away
from the disc to avoid interference.
Remove the side collar and pull the rear wheel from the final
drive gear. Remove the rear wheel.
Installation
Coat the driven flange with molybdenum disulfide grease.
lnstall the brake drum onto the wheel hub.
Place the rear wheel into the swingarm.
Date of Issue : March, 1995
16-6
o
HONDA
MOTOR CO.,LTD.