Egine Oil Filter Screen; Cartridge-Type Paper Filter; Element-Type Paper Filter - Honda Motorcycle Service Manual

MAINTENANCE
Cartridge-Type Paper Filter
Cartridge-type oil filters are removed using a filter wrench.
remain hot for some time after the engine is run. Wear in-
sulated gloves or wait until the engine and exhaust
system have cooled before handling these parts.
Clean the filter area of the engine with a clean cloth.
I
Spread engine oil thinly over the O-ring of the new filter and at-
tach the filter to the engine.
Tighten the oil filter with the proper filter wrench.
Run,the engine for about a minute, then stop it and inspect
carefully for leaks.
Element-Type Paper Filter
Remove the oil filter cover and replace the filter element.
Reinstall the cover with a new O-ring.
NOTE
Oil Filter Wrench
(For small-type cartridgel 07HAA-PJ70100 1/12 TURN
(For large-type cartridge) 07912-61 10001
Torque:
Small-type cartridge: 10 N . m ( l
.O
kg-m, 7 ft-lb)
Small-type cartridge with scale: 2 6 N.rn(2.6 kg-m, 19 ft-lb)
Large-type cartridge: 1 8 N - m ( l . 8 kg-m, 1 3 ft-lb)
Small-type cartridge with scale can be tighten by the following
procedure
Install the oil filter and fully hand-tighten.
Tighten the oil filter using a filter wrench to rotate 111 2 turn.
NOTE
.
Tighten 1/12 turn along the oil filter marker line.
P
J
Install the element with the rubber seal side facing out,
mak~na sure that the sorinq is installed between the
Confirm that there is no oil leakage by starting the engine after
the engine oil has been set at its proper level.
OIL FILTER COVER
RUBBER
\
SEAL
Replenish the engine oil with the proper type and viscosity,
and t o the proper level. Always run the engine and check for
oil leaks and verify the oil level after an oil or oil and filter
change.
-
.
"
element and crankcase.
.
If the element is installed incorrectly, it will reduce oil
flow.
Replace the O-ring on the filter cover with a new one.
ENGINE OIL FILTER SCREEN
O-RING
Check to see if there is any dirt or debris on the oil filter screen
which might hinder the flow of oil. Remove and clean the
screen in solvent if any deposits are found on the screen.
Refer to the Model Specific manual for oil filter screen removal.
cleaning and installation procedures for specific models.
Date of Issue March,1995
2-14
o
HONDA MOTOR
co
.LTD