Honda Motorcycle Service Manual page 187

CLUTCH
lnstall the clutch center B, the one-way clutch and one-way
1
clutch inner as an assembly onto the clutch outer.
NOTE
See page 11-18 for one-way clutch assembly.
.
Make sure that the one-way clutch is installed correctly
by turning clutch center B. The clutch center should turn
in the specified direction freely and should not turn in the
opposite direction.
I
CLUTCH CENTER B, ONE-WAY CLUTCH AND
ONE-WAY CLUTCH INNER
Coat the clutch plates and discs w i t h clean engine oil and in-
stall them in the clutch outer and on the clutch center.
NOTE
SECOND AND THIRD DISC (Different-groove pattern)
Two discs have different groove patterns than the other
discs. lnstall these t w o i n the SECOND and THIRD disc
positions (from the mainshaft).
Do not move clutch center B after installing the discs and
clutch plates.
I
1
3
PLATES AND DISCS
Install the pressure plate.
lnstall the washers, clutch spring and set plate.
NOTE
.
lnstall the clutch spring with concave side toward the
inside.
PRESSURE
WASHER
Put the transmission in top gear and apply the rear brake. Then
tighten the lock nut to the specified torque.
lnstall the lock washer and lock nut (see page 11-20).
NOTE
If the engine is not in the frame, shift the transmission in-
t o top gear, hold the drive sprocket w i t h the universal
holder, and tighten the lock nut.
LOCK WASHER AND LOCK NUT
Date of Issue: Sep., 1 9 8 8
0
HONDA MOTOR CO.. LTD