Starter Relay Switch; Starter Relay Switch Inspection; Starter Relay Voltage - Honda Motorcycle Service Manual

ELECTRIC STARTERISTARTER CLUTCH
STARTER RELAY SWITCH
The starter system can be divided into t w o basic circuits. There are the clutch safety type (A circuit) and the brake Safety type
(B circuit).
(A) When the starter switch is turned ON, battery voltage
(B) When the brake light switch is turned ON, the same
reaches the starter reley switeh.
voltage as that at the brake light switch is applied to
the starter relay switch. If the starter switch is turned
If the neutral or clutch switch of the ground line is ON, current flows through the relay and the starter
turned ON, current flows through the relay and the
motor operates. This type is commonly used with a
starter motor operates. centrifugal clutch.
CLUTCH SWITCH
DIODE
STARTER RELAY
\
SWITCH
INSPECTION
If you suspect a problem with the starter motorlsystem, check
~f the starter relay switch
"
clicks" when
it
isturned ON.
Inspect further for
'
Clicks
-
.
Poorly connected B (battery) terminal and M
(motor) terminal of the switch. (Check the
relay switch.)
*
No click-,
.
No relay input voltage
(Check relay input voltage.)
Faulty relay ground line
(Check around line.)
(check reley switch.)
Starter Relay Voltage
<Circuit A+
Measure the voltage between the yellowlred wire
(+I
and
ground at the starter relay switch connector.
If battery voltage is measured only when the starter switch is
pressed, the relay is good.
BRAKE LIGHT SWITCH
IGNITION SWITCH
R
S T A ~ T E R
RELAY SWITCH
STARTER
RELAY SWITCH
CONNECTOR
STARTER
RELAY SWITCH
Date of issue : March,
1995
24-6
0
HONDA MOTOR CO.,LTD.