Breather Hole Cleaning; Gear Case Assembly/Installation - Honda Motorcycle Service Manual

FINAL DRIVEIOUTPUT SHAFT
BREATHER HOLE CLEANING
BREATHER HOLE
,
GEAR CASE ASSEMBLYIINSTALLATION
0
BREATYER HOLE
Remove the breather hole cap and blow compressed air
through the hole.
Clean all sealing material off the mating surfaces of the gear
case and cover.
NOTE
Keep dust and dirt out of the gear case.
Be careful not t o damage the mating surfaces.
Apply liquid sealant t o the mating surfaces of the gear case
and cover.
BREATHER HOLE CAP
Install the gear case cover.
Tighten the cover bolts in 2 or 3 steps until the cover evenly
touches the gear case, then tighten the 8 rnm bolts t o the
specified torque in a crisscross pattern in t w o or more steps.
Next, tighten the
10
m m bolts t o the specified torque.
Make sure that the gears rotate smoothly without binding.
Install the dust guard plate and tighten the bolt securely, Install
the collar.
Install the drive shaft (see page 15-8),
I
DISTANCE COLLAR
Date of Issue: March,
1995
0
HONDA MOTOR CO.,LTD.
Apply molybdenum disulfide grease to the splines of the drive
shaft.
Insert the drive shaft into the universal joint, and attach the
gear case t o the swing arm with the mounting nuts.
After installing the wheel, tighten the gear case mounting nuts
t o the specified torque.
Fill the final drive with the specified type and amount of oil.
FINAL DRIVE
~-
NUTS