Headlight Bulb; Discharge Volume Inspection - Honda Motorcycle Service Manual

LIGHTSIMETERSISWITCHES
DISCHARGE VOLUME INSPECTION
Turn the ignition switch OFF
Turn on fuel valve. On models with vacuum operated valve,
apply vacuum
Disconnect the fuel pump-to-carburetor tube from the car-
buretor and place the tube end in a beaker.
NOTE
If
it
will be hard to reconnect the tube to the carburetor,
disconnect it from the fuel pump instead and connect
another tube t o the pump (gasoline discharge pori)
L I
Refer to step 3 of INSPECTION and short the relay connectors.
If the relay is built into the pump, short the black and
blacklyellow wires.
Turn the ignition switch ON for 5 seconds and run the pump.
Multiply the quantity of fuel pumped by 12. it should be as
specified in the Model Specific manual.
HEADLIGHT BULB
Before replacing the bulb, be sure to check the switches for
loose connection of the connectors.
Halogen headlight bulbs become very hot while the
headlight is ON, and remain hot for a while after they are
turned OFF. Be sure t o turn the ignition switch OFF and
let the bulb cool down before reolacement.
If you touch the bulb with your bare hands, clean it with a cloth
moistened with denatured alcohol to prevent early bulb failure.
CAUTION
I
Avoid touching Halogen headlight bulbs. Finger prints
can create hot s ~ o t s that cause a bulb to break.
Be sure to install the dust cover after replacing the bulb
JUMPER WIRE FUEL PUMP
I
I
FUEL LINE BEAKER
Date of Issue: March,
1995
o
HONDA MOTOR CO.,LTD.
25-11