Clatch Master Cylinder Removal/Disassembly - Honda Motorcycle Service Manual

CLUTCH
AIR BLEEDING
1
UPPER LEVEL DlnPHRAGM
1 ) Squeeze the clutch lever, open the bleed valve 112 turn
then close the valve.
I
been closed.
Check the fluid level often while bleeding the system to
Repeal the above procedures until air bubbles no longer appear
l l
21 Release the clutch lever slowly and wait several seconds
after it is fully released, before repeating the procedure.
at the end of the hose.
I
BLEED VALVE
I
'
LOWER LEVEL
Tighten the bleed valve to the specified torque.
Fill the clutch fluid reservoir to the upper level.
Install the diaphragm, diaphragm cover and reservoir cover.
CLUTCH MASTER CYLINDER
RemovallDisassembly
Place a rag over painted, plastic or rubber parts whenever the
HOSE BOLT
svstem is serviced.
CAUTION
[
.
S ~ i l i e d fluid will damage painted, plastic, or rubber parts.
/
Disconnect the clutch switch wires, and remove the clutch
hose bolt and t w o sealing washers.
Cover the end of the hose with a clean rag to prevent con-
tamination of the system. Then secure the hose to the
handlebar.
Remove the holder bolts and holder, then remove the master
cylinder from the handlebar.
I I
HOLDER
SEAL IN^
WASHERS
BOOT
P ~ S H ROD
Date of Issue: Sep., 1988
O
HONDA MOTOR CO., LTD.