Wheel Removal/Installation; Front Wheel; Axle Nut Type Removal; Axle Nut Type Installation - Honda Motorcycle Service Manual

WHEEL REMOVAL/INSTALLATlON
FRONT WHEEL
cam and anchor pin.
.
Inhaled asbestos fibers have been found to cause respiratory disease and cancer. Never use an air hose or dry brush to
clean brake assemblies. Use an OSHA-approved vacuum cleaner or alternate method approved by OSHA, designed to
.
Raise the vehicle off the ground by placing a jack or other support under the engine.
-
The speedometer cable and front brake cable must be disconnected.
.
On vehicles with hydraulic disc brakes, if the wheel cannot be removed with brake caliper(s) installed on the fork legs,
remove the wheel after removina the brake caliper with the caliper bracket attached
.
After installing the wheel, checkthat it turns smoothly and without binding
AXLE NUT TYPE
Removal:
Remove the axle nut
Pull the axle from the fork legs while holding the wheel, then
remove the wheel.
Installation
Drum brake: Align the speedometer gearbox retainer tabs with
the cutouts and install the brake drum on the wheel hub.
Install the side collar.
Coat the axle with a small amount of grease
Place the wheel between the fork legs while aligning the boss
on the fork leg with the groove in the brake panel. Insert the
axle through the fork legs.
Turn the front wheel so that the speedometer gear retainer
will engage properly with the wheel hub.
Hydraulic disc brake: Align the stop on the speedometer
gearbox with the boss on the fork leg
Set the wheel so that the brake disc is positioned between the
brake pads. Usecare n o t t o damage the brake pads. Install the
axle.
Tighten the axle nut to the specified torque. (Refer to the
Model Specific manual.)
Connect the cables.
16-2
Date of Issue: March.1995
0
HONDA MOTOR CO..LTD.